- #Saab tis2000 software and dongle key how to#
- #Saab tis2000 software and dongle key code#
- #Saab tis2000 software and dongle key Pc#
- #Saab tis2000 software and dongle key download#
#Saab tis2000 software and dongle key download#
At the end of the download the Tech 2 shows the message “Programming was successful”. The button “Exit” leaves the program. First, turn off the ignition of the vehicle, then switch off the Tech 2 and disconnect it from the vehicle.
#Saab tis2000 software and dongle key how to#
Hardware keys that have already been registered are still valid!
#Saab tis2000 software and dongle key code#
Note: The hardware key (HWK) has to be registered prior to working with ‘Service Programming System’. To register a hardware key, the form that is enclosed with the hardware key kit has to be filled in and sent to the address at the top. In case the form is missing, the document is also in the TIS 2000 newsletter (see icon in the TIS 2000 tool bar). At first, the user receives a temporary code until the key is registered on the next TIS 2000 CD. If you need to program Saab ECU, you had to use Saab TIS2000 and USB dongle. TIS2000 can only work gm cars until 2007, and software must work together with TIS2000 USB key.
#Saab tis2000 software and dongle key Pc#
Kindly notice: Before using the SPS, make sure that the Tech 2 scan tool and the pc contain the latest software, the battery of the vehicle is fully charged, only the ignition is on power, and all cables are connected properly. This is the steps on how to Use GM TECH2 Scanner to Program ECU with SPS (Service Programming System) in TIS2000 with usbkey. How to Use GM TECH2 Scanner to Program ECU with SPS in TIS2000